The QTMS Copycounter 4 counts a very wide range of shingled copy.
- It is robust and accurate.
- It uses safe Infrared LEDs to illuminate the copy.
- It determines the count from the leading edge of each product.
- Used widely for stacker and pre waste gate counting
- Simple to install
The Metrecount measures the linear usage of material of web systems.
- Robust and accurate
- Long life and low maintenance
- Web tracking
- Damped wheel suspension
- Easy install on 1 inch bar
The Reelstand Data Terminal is a data collector that controls the milljoin detection, Metrecount sensor and splice signal.
- Fast and accurate milljoin detection.
- Very wide range of product.
- Fast web break detection.
- Self calibrating - no adjustment after installation.
- Fault signal when faults detected.
The General Purpose Interface modifies signals for acceptance by PLC or data collector.
- Set signal pulse time output.
- Divide by 1, 2 and 4 output.
- Full isolation input and output.
- Inhibit allows last full pulse out.
CC4 Copycounter
MC1 Metrecount
RDT1 Reelstand
GPIF Interface
Netcom 2
The Netcom 2 allows you to connect your RS232 or RS422 device to the local network.
- Options: RS232C, RS232 TTL (serial from TTL source) or RS 422
- IP address set manually or by auto DHCP from router.
- Voltage options: 5, 12, 24 VDC.
- Typical application: printers, weighscales, barcode readers, totalisers
Copycounter 2 & 3
The manufacturing of QTMS Copycounters versions 2 and 3 has been discontinued. In line with the ethos of this company we continue to support the products for service, repair and advice.
These sensors have been superceded by the recent release of Copycounter 4
MJRL Milljoin Sensor
The Milljoin sensor Lamp passes light through the web to the Receiver that checks for the presence of a milljoin or splice.
- Fast response time to detection of milljoin/splice.
- Accounts for web flap.
- Safe red light, not laser.
- Immune to ambient light fluctuation.
Parts
Spares
A range of useful add-on parts are available:
- Air Impulse Marker.
- Count Master totaliser and batching system.
- Signal modifier devices.
- Test devices.
A range of spares are available:
- Replacement cables 3m, 5m, 10m and 15m for any SSC sensor.
- Mounting blocks and support brackets.
